|
Race located in Fort Myers, Florida. Weather in mid-60's to 70's, track was very smooth, medium to high traction. No sugar water or VHT was sprayed. Track design best described as short and technical, yet fast with very little hard braking.
Front
Camber: -2
Caster: One large clip in front of the upper arms
Toe: 1 out
Shock oil: 450cps
Shock Spring: short Mugen white
Shock Piston: 2-hole
Shock mounted on lowest hole on tower
Sway bar: 45 degrees
Droop: 1
Long wheelbase setting
All roll center blocks set on low
"B" Servo Saver, forward holes
Rear
Camber: -2
Toe: 2 in
Shock Oil: 450cps
Shock Spring: long Mugen white
Shock Piston: 2-hole
Shock mounted on hole drilled 10mm up from tower mounting screw, some dremeling necessary
Sway bar: X82019 Bar dremeled down to 2mm
Droop: 10 (measured under hub carrier, use Power Racing or Hudy blocks)
Clutch
All stock parts except for X82017 Rulon shoe. 1mm measurement from top of clutch nut to spring retainer.
Gearing
Stock (16/19) (45/49)
Engine
Collari LC21
Pipe
Power Racing Y2086 Hard Anodized pipe
Body
Y9190 Lola VDS
Tires
Enneti 35's for practice, Jaco 38's for qualifying and main events. 66.5mm front, 73.5mm rear
Email your Setup to Power Racing at Support@happytimehobby.com and get it posted on this site!
|
